Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Cinese

Traduzione in corso passo 7

Passo 7
Once you have sliced around the phone, twist an opening pick in one of the edges to help separate the back cover from the frame. Lift the back cover slowly. Use opening picks to slice any remaining adhesive. Remove the back cover.
  • Once you have sliced around the phone, twist an opening pick in one of the edges to help separate the back cover from the frame.

  • Lift the back cover slowly. Use opening picks to slice any remaining adhesive.

  • Remove the back cover.

  • During reassembly, this is a good point to power on your phone and test all functions before you seal the back cover in place. Be sure to power your phone back down completely before you continue working.

  • Follow this guide to reinstall the back cover, transfer and install the camera bezel, and replace the adhesive.

  • If desired, you may reinstall the back cover without replacing the adhesive. Remove any large chunks of adhesive that might prevent the back cover from sitting down flush. After installation, heat the back cover and apply pressure to secure it.

在手机上划开之后,扭动其中一个边缘的三角撬片,以帮助将后盖与框架分开。

慢慢抬起后盖。使用三角撬片切割任何剩余的粘合剂。

取下后盖。

在重新安装后盖之前,务必清除框架上的所有粘合剂残留物。在继续工作之前,请确保完全关闭手机电源。

在重新组装过程中,在将后盖密封到位之前,这是打开手机电源并测试所有功能的号时机。在继续工作之前,请务必将手机完全重新打开。

要密封手机,请将预先切割的粘合剂或双面Tesa 胶带粘贴到框架周边,然后将后盖牢固地按入到位。

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.