Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Giapponese

Traduzione in corso passo 20

Passo 20
Slide the lower left pick to the lower left corner to cut the adhesive on that corner. Leave the pick at the corner. Do not pry any farther, and do not remove the pick from the iPad. There are quite a few things to avoid beneath the lower bezel, so study the third image closely:
  • Slide the lower left pick to the lower left corner to cut the adhesive on that corner.

  • Leave the pick at the corner. Do not pry any farther, and do not remove the pick from the iPad.

  • There are quite a few things to avoid beneath the lower bezel, so study the third image closely:

  • Antennas

  • Home button cavity

  • Digitizer cable

  • The following steps will direct you where to pry to avoid damage to these components. Only apply heat and pry where directed.

左側の下にピックを差し込み、スライドさせながら左側下の角の接着剤を完全に剥ぎ取ります。

角にピックを残します。これ以上iPadから動かしたり、こじ開けたりしないでください。

下部ベゼルの底には接触を避けたいパーツが幾つかあります。3番目の画像で何があるのか見てみましょう。

アンテナ

ホームボタンの穴

デジタイザーケーブル

次の手順ではこれらのコンポーネントにダメージを与えないで作業をする方法が書かれています。熱で温めて、記された箇所のみこじ開けてください。

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.