Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Nota: Stai modificando un prerequisito per la guida che stavi visualizzando. Tutte le modifiche avranno effetto su tutte le 3guide che includono questo passo.

Inglese
Tedesco

Traduzione in corso passo 7

Passo 7
Carefully disconnect the two antenna coax cables by prying them straight up from the logic board. Slide your tweezers or spudger underneath each cable until it's near the socket, and then gently twist or pry up to disconnect it. To reconnect each cable, align the connector directly over its socket, and then press down so it snaps into place.
Disconnect the antennas
  • Carefully disconnect the two antenna coax cables by prying them straight up from the logic board.

  • Slide your tweezers or spudger underneath each cable until it's near the socket, and then gently twist or pry up to disconnect it.

  • To reconnect each cable, align the connector directly over its socket, and then press down so it snaps into place.

Heble die beiden Antennen-Koaxialkabel gerade hoch und trenne sie behutsam vom Logic Board ab.

Schiebe eine Pinzette oder einen Spudger unter jedem Kabel so nahe wie möglich an den Anschluss heran, verdrehe behutsam das Werkzeug oder heble damit, bis sich das Kabel löst.

Richte zum Wiederanschließen der Kabel den Stecker direkt über dem Sockel aus und drücke ihn dann nach unten, bis er einrastet.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.