Aggiusta le tue cose Community Store

Reemplazo del ventilador de la Mac mini de finales de 2018

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto sulla guida che include questo passo.

Torna alla Guida
Inglese
Spagnolo
Passo successivo

Traduzione in corso passo 1

Passo 1
Mac mini Late 2018 Fan Replacement: passo 0, immagine 1 di 2 Mac mini Late 2018 Fan Replacement: passo 0, immagine 2 di 2

  • Use a T6 Torx driver to remove the four 7.2 mm screws securing the fan:

  • Two screws securing the fan to the logic board

  • Two screws with rubber shoulders securing the fan to the exhaust vent

  • Rubber grommets secure these screws to the fan, so they may not come out completely. Just make sure they are fully loosened.

Utiliza un destornillador T6 Torx para remover los cuatro tornillos de 7.2 mm que sujetan el ventilador:

Dos tornillos que sujetan el ventilador a la placa lógica

Dos tornillos que sujetan el ventilador a la salida de escape

Las arandelas de goma sujetan estos tornillos al ventilador, por lo que es posible que no salgan completamente. Solo asegúrate de que estén completamente sueltos.

[* black] Use a T6 Torx driver to remove the four 7.2 mm screws securing the fan:
[* red] Two screws securing the fan to the logic board
- [* orange] Two screws securing the fan to the exhaust vent
+ [* orange] Two screws with rubber shoulders securing the fan to the exhaust vent
[* icon_note] Rubber grommets secure these screws to the fan, so they may not come out completely. Just make sure they are fully loosened.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.