Aggiusta le tue cose Community Store

Reemplazo de la placa de antena en la Mac mini de finales de 2018

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Torna alla Guida
Inglese
Spagnolo
Passo precedente Passo successivo

Traduzione in corso passo 4

Passo 4
Mac mini Late 2018 Antenna Plate Replacement: passo 0, immagine 1 di 3 Mac mini Late 2018 Antenna Plate Replacement: passo 0, immagine 2 di 3 Mac mini Late 2018 Antenna Plate Replacement: passo 0, immagine 3 di 3

  • The antenna cable connector and socket are fragile.

  • Use the point of a spudger or fine tweezers to gently pry the antenna cable connector straight up off its socket on the logic board.

  • To reconnect the cable, use tweezers to position it carefully over its socket on the logic board, and then press it straight down until it snaps into place.

  • If you need more slack in the cable, you can temporarily pry it from the clips securing it to the antenna plate.

Tira suavemente del cable o usa la punta de un spudger para levantar su conector directamente de su zócalo en la placa lógica.

Para volver a conectar el cable, usa pinzas para colocarlo cuidadosamente sobre su zócalo en la placa lógica, y luego presiónalo firmemente hasta que encaje en su lugar.

Si necesitas más holgura en el cable, puedes separarlo temporalmente de los clips que lo sujetan a la placa de la antena.

-[* black] Gently pull the cable or use the point of a spudger to lift its connector straight up off its socket on the logic board.
-[* icon_reminder] To reconnect the cable, use tweezers to position it carefully over its socket on the logic board, and then press it down firmly until it snaps into place.
+[* icon_caution] The antenna cable connector and socket are fragile.
+[* black] Use the point of a spudger or fine [product|IF145-020|tweezers] to gently pry the antenna cable connector straight up off its socket on the logic board.
+[* icon_reminder] To reconnect the cable, use tweezers to position it carefully over its socket on the logic board, and then press it straight down until it snaps into place.
[* icon_reminder] If you need more slack in the cable, you can temporarily pry it from the clips securing it to the antenna plate.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.