Salta al contenuto principale
Inglese
Giapponese

Traduzione in corso passo 4

Passo 4
Use a spudger to gently pry the battery connector straight up from its socket on the motherboard. This will keep the Joy-Con from powering on during the repair. Be very careful as you pry up the connector—if it doesn't come up with the spudger, try gently pulling the cables straight up from the board to disconnect it.
  • Use a spudger to gently pry the battery connector straight up from its socket on the motherboard. This will keep the Joy-Con from powering on during the repair.

  • Be very careful as you pry up the connector—if it doesn't come up with the spudger, try gently pulling the cables straight up from the board to disconnect it.

  • During reassembly, press the connector straight down into its socket on the board to reconnect the battery.

スパッジャーを使って、マザーボード上のソケットからバッテリーコネクタを慎重にこじ開けます。この作業で、Joy-Conの電源が入らないように保てます。

コネクタをこじ開ける際は、特に注意を払ってください。スパッジャーで作業が上手く進まない場合、慎重にケーブルをボードから引き抜いて接続を外します。

再組み立ての際は、ボード上のソケットにコネクタをまっすぐ押し込んで差し込み、バッテリーを接続します。

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.