Salta al contenuto principale
Inglese
Olandese

Traduzione in corso passo 2

Passo 2
Insert an opening pick into the seam at the bottom edge of the controller (opposite the L and ZL buttons). Slowly slide the flat edge of your opening pick up the side of the Joy-Con. Be careful not to slide the opening pick too far inside the Joy-Con. This may damage the inner components. The back panel loosens fairly easily, so not much pressure is needed.
  • Insert an opening pick into the seam at the bottom edge of the controller (opposite the L and ZL buttons).

  • Slowly slide the flat edge of your opening pick up the side of the Joy-Con.

  • Be careful not to slide the opening pick too far inside the Joy-Con. This may damage the inner components. The back panel loosens fairly easily, so not much pressure is needed.

Steek een openingsplectrum in de naad aan de onderkant van de controller (tegenover de L- en ZL-knoppen).

Schuif de platte kant van je openingsplectrum langzaam langs de zijkant van de Joy-Con omhoog.

Zorg ervoor dat je je openingsplectrum niet te diep in de Joy-Con steekt. Dit kan de binnenste onderdelen beschadigen. Het achterste paneel komt relatief makkelijk los, dus je hebt niet veel druk nodig.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.