Salta al contenuto principale
Inglese
Giapponese

Traduzione in corso passo 2

Passo 2
Insert an opening pick into the seam at the bottom edge of the controller (opposite the L and ZL buttons). Slowly slide the flat edge of your opening pick up the side of the Joy-Con. Be careful not to slide the opening pick too far inside the Joy-Con. This may damage the inner components. The back panel loosens fairly easily, so not much pressure is needed.
  • Insert an opening pick into the seam at the bottom edge of the controller (opposite the L and ZL buttons).

  • Slowly slide the flat edge of your opening pick up the side of the Joy-Con.

  • Be careful not to slide the opening pick too far inside the Joy-Con. This may damage the inner components. The back panel loosens fairly easily, so not much pressure is needed.

開口ピックをコントローラの下側端のシーム部分に差し込みます。(LとZLボタンの反対側)

Joy-Con横側に沿って、開口ピックの先端を水平にスライドします。

Joy-Conの内側深くまで開口ピックをスライドしないでください。内部コンポーネントにダメージを与えてしまう可能性があります。バックパネルは簡単に外れます。圧力をかけ過ぎる必要はありません。

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.