Salta al contenuto principale
Cinese
Inglese

Traduzione in corso passo 8

Passo 8
用热风枪加热,上盖金属连接部件,这里温度要稍微高一些,大概在90到100多度左右,加热20几秒后,(注意环境温度和加热,时间成反比)最后用尖嘴钳夹住金属连接扣两边,左右摇晃,用力拉出 用热风枪加热,上盖金属连接部件,这里温度要稍微高一些,大概在90到100多度左右,加热20几秒后,(注意环境温度和加热,时间成反比)最后用尖嘴钳夹住金属连接扣两边,左右摇晃,用力拉出 用热风枪加热,上盖金属连接部件,这里温度要稍微高一些,大概在90到100多度左右,加热20几秒后,(注意环境温度和加热,时间成反比)最后用尖嘴钳夹住金属连接扣两边,左右摇晃,用力拉出
  • 用热风枪加热,上盖金属连接部件,这里温度要稍微高一些,大概在90到100多度左右,加热20几秒后,(注意环境温度和加热,时间成反比)最后用尖嘴钳夹住金属连接扣两边,左右摇晃,用力拉出

Heat with a hot air gun, cover the metal connection parts, the temperature here is slightly higher, about 90 to more than 100 degrees, after heating for 20 seconds.

Heat with a hot air gun, cover the metal connection parts, the temperature here is slightly higher, about 90 to more than 100 degrees, after heating for 20 seconds.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.