Salta al contenuto principale
Inglese
Italiano

Traduzione in corso passo 3

Passo 3
To remove bolt: use the 2 ¾” wrenches to loosen the nut on the bottom from the bolt on the top of the sprocket. Remove bolt, noting the order of everything in the assembly.
INSTALLATION
  • To remove bolt: use the 2 ¾” wrenches to loosen the nut on the bottom from the bolt on the top of the sprocket. Remove bolt, noting the order of everything in the assembly.

  • Put the sprocket directly onto the bolt once everything is off the bolt with the flat side towards the bolt head.

  • Place the washer on the bolt, followed by the nut (tighten), followed by the lock washer.

  • Pull the chain tight over the sprocket and insert the bolt into the hole in the bracket attached to the wall.

  • Tighten down the last nut with both of the ¾” wrenches.

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.