Salta al contenuto principale
Inglese
Italiano

Traduzione in corso passo 24

Passo 24
When installing the actuator back into the door cavity, it will take a bit of trial and error to get the actuator fitting into its proper placement.
Re-installation of actuator assembly - Note
  • When installing the actuator back into the door cavity, it will take a bit of trial and error to get the actuator fitting into its proper placement.

  • As I mentioned previously, this particular assembly uses a "fork" on the inside of the door handle which slips onto a horizontal metal bar.

  • Once the actuator is in the general area that it needs to be, you'll have to start with the actuator below the door handle height and then feel for the fork and slide the actuator so that the fork slips over the bar as you bring it upwards and into position with latch metal plate torx bolt holes lined up.

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.