Traduzione in corso passo 7
Passo 7

-
Now you will have to remove the existing contacts by way of clipping the line of at an appropriate length away from the contacts.
-
Now solder on your new connections on the board.
-
For the connections to the casing, you should be able to remove them with a little force. If you feel like you are using too much force, feel free to use a heat gun to eliminate some adhesive on the casing side of the contact.
-
Finally, adhere the new contacts to the casing with a "super glue" like Krazy glue.
I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.