Aggiusta le tue cose Community Store

Remplacement de l'écran LCD du nikon s3700

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto sulla guida che include questo passo.

Torna alla Guida
Inglese
Francese
Passo precedente

Traduzione in corso passo 2

Passo 2
nikon s3700 LCD Display Screen Replacement, Replace LCD: passo 0, immagine 1 di 3 nikon s3700 LCD Display Screen Replacement, Replace LCD: passo 0, immagine 2 di 3 nikon s3700 LCD Display Screen Replacement, Replace LCD: passo 0, immagine 3 di 3
Replace LCD

  • Remove Rear casing.

  • With a thin blade, gently lift the top tight hand side of the buttons board releasing a peg from a hole on the midframe below. Whilst doing so, gently push on the top left hand side in order to release the buttons board from a clip. At the same time, the bottom left hand corner wil be released from another clip.

  • Flip over rear buttons board to expose LCD ZIF clamp.

  • Flip open the clamp of the ZIF connector and slide the ribbon cable out. (The connector may have a piece of sticky tape over it. Removing this may well open the connector clamping bar.)

  • The ZIF clamp is very fragile so please use caution when releasing the ZIF clamp. It breaks easily.

  • Remove the LCD.

Remplacez l'écran LCD

Retirez le boîtier arrière.

Retournez le panneau d'options arrière pour exposer la pince LCD ZIF.

Ouvrez la pince du connecteur ZIF et faites glisser le câble ruban vers l'extérieur.

La pince ZIF est très fragile donc soyez prudent lorsque vous relâchez la pince ZIF. Ça casse facilement.

Retirez l'écran LCD.

[title] Replace LCD
[* black] Remove Rear casing.
-[* black] Flip over rear options panel to expose LCD ZIF clamp.
-[* red] Flip open the clamp of the ZIF connector and slide the ribbon cable out.
+[* red] With a thin blade, gently lift the top tight hand side of the buttons board releasing a peg from a hole on the midframe below. Whilst doing so, gently push on the top left hand side in order to release the buttons board from a clip. At the same time, the bottom left hand corner wil be released from another clip.
+[* black] Flip over rear buttons board to expose LCD ZIF clamp.
+[* black] Flip open the clamp of the ZIF connector and slide the ribbon cable out. (The connector may have a piece of sticky tape over it. Removing this may well open the connector clamping bar.)
[* icon_caution] The ZIF clamp is very fragile so please use caution when releasing the ZIF clamp. It breaks easily.
[* black] Remove the LCD.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.