Salta al contenuto principale
Inglese
Italiano

Traduzione in corso passo 9

Passo 9
remove nut using a wrench . There should also be a small washer but they usually get stuck inside , they should fall out during the next step. Next this bolt will need to be tapped out . you can either LIGHTLY tap it with a wrench from the threaded end ( see last step)  or you can use vice grips . Once Bolt is removed the arm is now loose . It  may require some hand force to detach it from the assembly .
  • remove nut using a wrench . There should also be a small washer but they usually get stuck inside , they should fall out during the next step.

  • Next this bolt will need to be tapped out . you can either LIGHTLY tap it with a wrench from the threaded end ( see last step) or you can use vice grips .

  • Once Bolt is removed the arm is now loose . It may require some hand force to detach it from the assembly .

  • Beware if you are working on the right side roller arm ( sitting position) there will be an extra sensor that needs to be unplugged

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.