Salta al contenuto principale
Inglese
Italiano

Traduzione in corso passo 2

Passo 2
next, remove the antenna bar. unlike the previous generation MacBook pros, the wifi antenna is not attached to the display assembly. To remove the antenna bar, start by removing the 12 screws located above the left/right heat sink vents by using a Pentalobe-2 (P2) bit. next, remove the shield plates by taking out the 8 T3 screws circled in green.
  • next, remove the antenna bar. unlike the previous generation MacBook pros, the wifi antenna is not attached to the display assembly.

  • To remove the antenna bar, start by removing the 12 screws located above the left/right heat sink vents by using a Pentalobe-2 (P2) bit.

  • next, remove the shield plates by taking out the 8 T3 screws circled in green.

  • after the shields are removed, lift up on the center snap-in connector on the antenna bar.

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.