Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Italiano

Traduzione in corso passo 1

Passo 1
When separating the sides of the screen assembly from the device's frame, you will need to release five metal clips securing it in place. Three of these clips are located on the left side of the device, and two are located on the right side.
  • When separating the sides of the screen assembly from the device's frame, you will need to release five metal clips securing it in place.

  • Three of these clips are located on the left side of the device, and two are located on the right side.

  • You will need to work around these clips with your opening pick in order to fully release them.

  • You can either carefully slide an opening pick around these clips, or leave a pick on one side of the clip while prying the other side with another pick.

Usando l'estremità piatta dello spudger in nylon, tira via il nastro adesivo nero disposto sopra il connettore dello schermo a cui è attaccato il nastro nero.

-[* black] Using the flat end of the nylon spudger, pull off the black tape on top of the screen connector piece that the black ribbon is attached to.
+[* red] When separating the sides of the screen assembly from the device's frame, you will need to release five metal clips securing it in place.
+ [* orange] Three of these clips are located on the left side of the device, and two are located on the right side.
+ [* black] You will need to work around these clips with your opening pick in order to fully release them.
+ [* black] You can either carefully slide an opening pick around these clips, or leave a pick on one side of the clip while prying the other side with another pick.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.