Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Inglese
Francese

Traduzione in corso passo 4

Passo 4
Use a spudger to carefully lever up the daughterboard and remove it. Don't break the small clamps that hold down the daughter board but press them a little bit to the side to make the removal easier. Use a spudger to remove the loudspeaker and the charging port. There is some adhesive underneath and the unit might be a little bit sticky. If you're having a hard time while removing the loudspeaker  you can use an iOpener to loosen the adhesive and try it again.
  • Use a spudger to carefully lever up the daughterboard and remove it. Don't break the small clamps that hold down the daughter board but press them a little bit to the side to make the removal easier.

  • Use a spudger to remove the loudspeaker and the charging port. There is some adhesive underneath and the unit might be a little bit sticky.

  • If you're having a hard time while removing the loudspeaker you can use an iOpener to loosen the adhesive and try it again.

Servez-vous de la spatule pour soulever et retirer soigneusement la carte fille. Ne cassez pas les petites attaches qui maintiennent la carte fille, mais appuyez légèrement sur le côté de ces attaches pour enlever le tout plus facilement.

Retirez la carte fille et le port de charge à l'aide de la spatule. Ces pièces sont collées et seront donc peut-être un peu récalcitrantes.

Si vous avez du mal à retirer le haut-parleur, vous pouvez utiliser un iOpener pour faire ramollir l'adhésif avant de réessayer.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.