Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Francese

Traduzione in corso passo 8

Passo 8
The top edge of the display is secured with both glue and clips. Slide the opening pick around the top corner of the display, while gently pulling or wiggling the display down in the direction of the Lightning port. The clips will break if you use too much force. Work carefully and be patient.
  • The top edge of the display is secured with both glue and clips.

  • Slide the opening pick around the top corner of the display, while gently pulling or wiggling the display down in the direction of the Lightning port.

  • The clips will break if you use too much force. Work carefully and be patient.

  • Again, don't insert the pick more than a few millimeters—about the width of the display bezel—or you may damage the front panel sensor array.

  • Slide the pick to the opposite corner and cut any remaining adhesive securing the display.

Le bord supérieur de l'écran est retenu par de la colle et des clips.

Glissez le médiator sous un coin supérieur de l'écran tout en faisant délicatement jouer l'écran vers le bas. en direction du port Lightning.

Les clips peuvent se casser si vous forcez trop. Progressez avec prudence et restez patient.

N'enfoncez pas non plus le médiator au-delà du joint de l'écran — quelques millimètres. Vous risqueriez d'endommager la rangée des capteurs du panneau frontal.

Glissez le médiator sous le côté opposé pour faire céder l'adhésif restant.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.