Electrolux LTE12 - Washing Machine Disassembly

Passo 1

Unplug the wall outlet.

Passo 2

Fasten the lid of the washing machine with a large crepe tape. Do not open when removing the top of the machine.

Passo 3

Open the top of the washer. Lift the back first. And then the front.

Passo 4

Remove the Phillips screw.

Passo 5

Remove the two Phillips screws.

Passo 6

To loosen the Control Panel cover, loosen the two Phillips screws. (Left side).

Passo 7

To loosen the Control Panel cover, also loosen the two Phillips screws on the right side.

Passo 8

Carefully lift the cover of the Control Panel. In this photo, the glass cover was removed to enlarge the image.

Passo 9

If there is a need to replace the Power Circuit Board, carefully pull out the program select button.

Passo 10

To remove the circuit board from the Panel buttons, remove the three Phillips screws. Disconnect the cable carefully.

Passo 11

If you need to replace any components on the button circuit board, loosen the three Phillips screws to remove the acrylic shield.

Passo 12

To change the pressure switch, cut the clamp and remove the

Passo 13

To assemble the Washing Machine, follow the same procedure, in the reverse order.