Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Tedesco

Traduzione in corso passo 1

Passo 1
Remove four Phillips screws securing the lower display cable bracket to the logic board, of the following lengths: Two 1.3 mm screws
  • Remove four Phillips screws securing the lower display cable bracket to the logic board, of the following lengths:

  • Two 1.3 mm screws

  • Two 2.8 mm screws

  • Throughout this guide, keep careful track of your screws so that each one goes back where it came from during reassembly. Installing a screw in the wrong place can cause permanent damage.

  • Remove the bracket.

Entferne die vier Kreuzschlitzschrauben, die die Halterung des unteren Displaykabels am Logic Board befestigen.

Zwei 1,3 mm Schrauben.

Zwei 2,8 mm Schrauben.

Entferne die Halterung.

[* black] Remove the four Phillips screws securing the lower display cable bracket to the logic boardboard, of the following lengths:
[* black] Remove the four Phillips screws securing the lower display cable bracket to the logic boardboard, of the following lengths:
[* red] Two 1.3 mm screws
[* orange] Two 2.8 mm screws
[* icon_reminder] Throughout this guide, [product|IF145-167-4|keep careful track of your screws] so that each one goes back where it came from during reassembly. Installing a screw in the wrong place can cause permanent damage.
[* black] Remove the bracket.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.