Introduzione

The camera is attached to the motherboard in your phone. A T6 screwdriver is needed to access the camera.

Parti

Nessuna parte richiesta.

  1. Press down the button on the back panel.
    • Press down the button on the back panel.

  2. Push the back cover upwards. Push the back cover upwards.
    • Push the back cover upwards.

  3. Remove the back cover from the phone. Remove the back cover from the phone.
    • Remove the back cover from the phone.

  4. Press the silver button on the top of the phone.
    • Press the silver button on the top of the phone.

  5. Slide your thumbnail down the case seam to separate the rest of the case.
    • Slide your thumbnail down the case seam to separate the rest of the case.

  6. Gently, remove the case.
    • Gently, remove the case.

    • Careful! Do not bend the plastic tabs.

  7. Spedizione gratuita per tutti gli ordini superiori a 100 US$ o contenenti un Kit Attrezzi Pro Tech!

    Sfoglia il Nostro Negozio
  8. Using a T6 Torx Screwdriver, unscrew and remove the six screws shown in the picture. Using a T6 Torx Screwdriver, unscrew and remove the six screws shown in the picture.
    • Using a T6 Torx Screwdriver, unscrew and remove the six screws shown in the picture.

  9. Remove the panel that covers the motherboard. If replacing the speaker, stop at this step and skip forward to the first step of the speaker guide.
    • Remove the panel that covers the motherboard.

    • If replacing the speaker, stop at this step and skip forward to the first step of the speaker guide.

  10. Remove the LCD screen frame.
    • Remove the LCD screen frame.

  11. Remove the motherboard.
    • Remove the motherboard.

  12. Locate the camera on the circuit board.
    • Locate the camera on the circuit board.

  13. Place the circuit board on a firm, static free surface (no cloth/carpet).
    • Place the circuit board on a firm, static free surface (no cloth/carpet).

    • NOTE: The circled alignment notch points to the left.

  14. Pull the left holding tabs to the left.
    • Pull the left holding tabs to the left.

  15. Lift out the left side of the camera.
    • Lift out the left side of the camera.

  16. Pull the right holding tabs to the right.
    • Pull the right holding tabs to the right.

  17. Pull camera off of board.
    • Pull camera off of board.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Job Jao

Membro da: 08/10/2010

37 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 3-27, Regan Fall 2010 Membro di Cal Poly, Team 3-27, Regan Fall 2010

CPSU-REGAN-F10S3G27

4 Membri

9 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 1

Tutti i Tempi: 1,766