Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
group screws according to color code.
-
Remove exterior screws
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove Rear casing.
-
With a thin blade, gently lift the top tight hand side of the buttons board releasing a peg from a hole on the midframe below. Whilst doing so, gently push on the top left hand side in order to release the buttons board from a clip. At the same time, the bottom left hand corner wil be released from another clip.
-
Flip over rear buttons board to expose LCD ZIF clamp.
-
Flip open the clamp of the ZIF connector and slide the ribbon cable out. (The connector may have a piece of sticky tape over it. Removing this may well open the connector clamping bar.)
-
Remove the LCD.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.