Philips Wake-Up HF35xx Disassembly

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Torna alla Guida

Inglese

Italiano

Passo precedente

Traduzione in corso passo 7

Passo 7

Philips Wake-Up HF35xx Disassembly, Remove back cover (Optional but recommended): passo 0, immagine 1 di 2

Philips Wake-Up HF35xx Disassembly, Remove back cover (Optional but recommended): passo 0, immagine 2 di 2

Remove back cover (Optional but recommended)

Disconnect the speaker from the main circuit board.
The antenna (a long white wire) has a fragile solder connection to the main circuit board and care should be taken to not yank upon it.
Loosen the screw and washer inside the back cover by the speaker and unwrap the antenna wire that was pinned underneath. Pull the antenna all the way through so the back cover can be removed.
Alternately, you may simply pull only some of it through so that the wire is slack enough that the solder joint is at no risk.
Caution: The speaker and the buzzer connectors are the same so be careful when reassembling.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.