Petcube Play 2 Laser Replacement

Inglese

Italiano

Traduzione in corso passo 3

Passo 3

Use a spudger, or a clean fingernail to flip up the locking flap—this is the unlocked position.
Use the widest tool possible to avoid damaging the delicate hinge pins.
Use tweezers or your fingers to gently pull the cable out of its socket and remove the laser assembly from the board.
Be gentle and patient as the ribbon cable is delicate and can break easily.
To reconnect, make sure the locking flap is flipped up and gently reinsert the cable. Then, flip the locking flap down to secure the cable. The cable should slide into the socket with little to no force. If you're having trouble, remove it, check that the flap is fully unlocked, and try again.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.