Salta al contenuto principale

Sostituzione ventola Mac mini 2018

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto sulla guida che include questo passo.

Inglese
Italiano

Traduzione in corso passo 1

Passo 1
Mac mini Late 2018 Fan Replacement: passo 0, immagine 1 di 2 Mac mini Late 2018 Fan Replacement: passo 0, immagine 2 di 2
  • Use a T6 Torx driver to remove the four 7.2 mm screws securing the fan:

  • Two screws securing the fan to the logic board

  • Two screws with rubber shoulders securing the fan to the exhaust vent

  • Rubber grommets secure these screws to the fan, so they may not come out completely. Just make sure they are fully loosened.

Usa un cacciavite Torx T6 per rimuovere le quattro viti da 7,2 mm che assicurano la ventola.

Due viti assicurano la ventola alla scheda madre.

Due viti assicurano la ventola allo scarico dell'aria.

Degli occhielli di gomma assicurano queste viti alla ventola, per questo le viti potrebbero non uscire completamente. Assicurati solo che sono completamente svitate.

[* black] Use a T6 Torx driver to remove the four 7.2 mm screws securing the fan:
[* red] Two screws securing the fan to the logic board
- [* orange] Two screws securing the fan to the exhaust vent
+ [* orange] Two screws with rubber shoulders securing the fan to the exhaust vent
[* icon_note] Rubber grommets secure these screws to the fan, so they may not come out completely. Just make sure they are fully loosened.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.