Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

iRobot Roomba 551 Brushes Replacement

Cosa ti serve

  1. iRobot Roomba 551 Brushes Replacement, Side Brush: passo 1, immagine 1 di 1
    • Place your Roomba upside-down on a hard surface.

  2. iRobot Roomba 551 Brushes Replacement: passo 2, immagine 1 di 1
    • While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.

  3. iRobot Roomba 551 Brushes Replacement: passo 3, immagine 1 di 1
    • Gently pull upwards on the brush to remove it.

  4. iRobot Roomba 551 Brushes Replacement, Bottom Plate: passo 4, immagine 1 di 1
    • Rotate the Roomba upside-down so the bottom is facing towards you.

  5. iRobot Roomba 551 Brushes Replacement: passo 5, immagine 1 di 2 iRobot Roomba 551 Brushes Replacement: passo 5, immagine 2 di 2
    • Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place.

  6. iRobot Roomba 551 Brushes Replacement: passo 6, immagine 1 di 1
    • Carefully lift the bottom plate.

    • The battery is only secured in place by the bottom plate, and may fall out once the bottom plate is removed.

  7. iRobot Roomba 551 Brushes Replacement, Brushes: passo 7, immagine 1 di 2 iRobot Roomba 551 Brushes Replacement, Brushes: passo 7, immagine 2 di 2
    • Pinch the yellow tabs on the sides of the brush cage and lift up to open.

  8. iRobot Roomba 551 Brushes Replacement: passo 8, immagine 1 di 3 iRobot Roomba 551 Brushes Replacement: passo 8, immagine 2 di 3 iRobot Roomba 551 Brushes Replacement: passo 8, immagine 3 di 3
    • Grab each brush and lift upwards to remove.

Conclusione

To reassemble your device, follow these instructions in reverse order.

John McTigue

Membro da: 01/31/14

331 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 13-14, Regan Winter 2014 Membro di Cal Poly, Team 13-14, Regan Winter 2014

CPSU-REGAN-W14S13G14

4 Membri

19 Guide realizzate

2 Commenti

Should be no need to remove the back plate. Just open the brush cage and lift out the brushes

Gunnar Nybraten - Replica

I did all that, bought a new brush cage and it is still announcing error 2-clean brushes.

Christa Eads - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 18

Ultimi 7 Giorni: 93

Ultimi 30 Giorni: 415

Tutti i Tempi: 5,545