Salta al contenuto principale

Introduzione

This guide explains how to remove the brush case from your Roomba.

Parti

Nessuna parte specificata.

  1. Place your Roomba upside-down on a hard surface.
    • Place your Roomba upside-down on a hard surface.

  2. While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.
    • While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.

  3. Gently pull upwards on the brush to remove it.
    • Gently pull upwards on the brush to remove it.

  4. Kit di riparazione batterie iPhone

    Solo $29.99

    Buy Now

    Kit di riparazione batterie iPhone

    Solo $29.99

    Buy Now
  5. Rotate the Roomba upside-down so the bottom is facing towards you.
    • Rotate the Roomba upside-down so the bottom is facing towards you.

  6. Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place. Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place.
    • Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place.

  7. Carefully lift the bottom plate.
    • Carefully lift the bottom plate.

    • The battery is only secured in place by the bottom plate, and may fall out once the bottom plate is removed.

  8. Push on the dirt bin release button, and pull gently.
    • Push on the dirt bin release button, and pull gently.

  9. Use a Phillips #1 screwdriver to loosen the 4 captive screws around the case .
    • Use a Phillips #1 screwdriver to loosen the 4 captive screws around the case .

  10. Grab the brush case and pull upwards to remove.
    • Grab the brush case and pull upwards to remove.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

John McTigue

Membro da: 31/01/2014

331 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 13-14, Regan Winter 2014 Membro di Cal Poly, Team 13-14, Regan Winter 2014

CPSU-REGAN-W14S13G14

4 Membri

13 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 506