Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the Roomba upside down so that the underside is exposed. The wheels and brushes should be visible.
-
Identify the brush guard, which is the black rectangular frame that the metal rods are attached to.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the 2 small rectangular yellow tabs on either side of the brush guard, directly adjacent to the blue flap.
-
Place index fingers on both tabs, and apply slight pressure in the direction of the yellow battery pack.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
After the guard hinges up, lift the guard up and away from the Roomba.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the wire brush by grabbing it by the yellow plastic part of the brush.
-
Pull the brush upwards until it comes out.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the rubber spinning brush by grabbing it by the rubber part on both ends.
-
Pull the brush upwards until it dislodges.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.