Salta al contenuto principale

iPod Touch 5th Generation Lightning Connector Assembly Replacement

Solo Prerequisita
Questa guida è destinata a essere usata solo come prerequisito per altre guide. Da sola è incompleta.

Cosa ti serve

  1. iPod Touch 5th Generation Lightning Connector Assembly Replacement, Lightning Connector Assembly: passo 1, immagine 1 di 1
    • Use the tip of a spudger to peel back a small piece of tape covering a screw on the left side of the headphone jack.

  2. iPod Touch 5th Generation Lightning Connector Assembly Replacement: passo 2, immagine 1 di 1
    • Remove the following screws securing the headphone jack, Lightning connector, and speaker.

    • Three 2.6 mm #000 Phillips screws

    • Two 2.0 mm #000 Phillips screws

  3. iPod Touch 5th Generation Lightning Connector Assembly Replacement: passo 3, immagine 1 di 1
    • Use the flat end of a spudger to pry the speaker up from the rear case.

    • Do not try to remove the speaker, as it is soldered to the Lightning connector assembly.

  4. iPod Touch 5th Generation Lightning Connector Assembly Replacement: passo 4, immagine 1 di 2 iPod Touch 5th Generation Lightning Connector Assembly Replacement: passo 4, immagine 2 di 2
    • Grasping the large ribbon cable, gently pull the Lightning connector assembly out of the bottom of the case.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

iFixit Membro di iFixit

Staff

136 Membri

16.573 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 225