Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
The picture at left (front panel already removed) shows the locations of the metal clips (shown in red) that snap on to the plastic frame. In the next few steps, try to pry the front panel up from the gaps between these clips.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Gently insert a plastic opening tool, near the volume control buttons, between the plastic surround of the screen and the metal case.
-
Rotate the tool away from the Touch to pry up on the glass panel.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert the plastic opening tool between the front panel and its plastic surround and pry up at several points along the left edge of the Touch.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Continue prying up the left edge until the top and bottom edges start to lift out of the Touch.
-
Once the top and bottom edges have lifted slightly out of the Touch, use the opening tool to assure the plastic surround is detached from the clips along the inside of the Touch.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Continue the prying procedure, now focusing on detaching the plastic surround from the internal metal clips.
-
Pry along the top edge of the Touch to further separate the front panel from the rest of the device.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pry up the front panel along the right edge using the method described in previous steps.
-
Eventually work around the entire perimeter of the front panel until it is lifted slightly from the rear panel.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the front panel out of the rear case minding the cable still attaching it near the upper left corner of the Touch.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the flat end of a spudger (or an opening tool) to pry the touch screen cable connector up off the upper logic board.
-
Annulla: non ho completato questa guida.
Altre 263 persone hanno completato questa guida.
15 Commenti
thanks guys! i fixed it and without you i would never do it! thaaaaankkksss!!! :D
great site!
watch out for the ribbon cable of the digitizer, its highly breakable! i had to order two new screens because i damaged the ribbon cables!
so please, really watch out with the ribbon cable!!!
Can anyone please help me I ordered a replacement screen and I put it all back to gether with out a hitch but now the middle row of Icons are not responding. Is there anything I can do to fix this issue? also the power button is not responding. anyone with suggestions are welcome thanks.
Sorry that this is literally 10 years late but, you probably damaged the ribbon cables during the opening process, you will need to order a new power button and a new display, these days it is literally impossible to find those parts so finding a new 2g on ebay is your best bet.