Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a spudger to pry up the white plastic hold switch.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
If present, remove the cap from the USB port.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
The following step can be challenging and time consuming. Be sure to go slowly and have patience to prevent damaging your iPod.
-
Use an Exacto knife to separate the glue holding the USB port on the iPod. Run the knife along the seam between the two sections of the iPod until the glue is separated. Expect to run the knife along this edge 20-30 times before the glue will be entirely freed.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Continue to run the knife around all four edges of the USB port until the glue is released. You may be able to gently wiggle the knife from side to side to help release the glue.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a spudger to push on the headphone jack and slide the USB port out of its housing.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
After the USB port comes free, carefully slide it out of its housing. Don't pull it out too far because there's still a ribbon cable connecting it to the logic board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Continue to slide the iPod out of its casing by using a spudger to push on the logic board near the headphone jack.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the iPod so that the click wheel is facing up. This will prevent the battery indicator from falling out.
-
Slide the iPod out of its casing.
-
Annulla: non ho completato questa guida.
Altre 6 persone hanno completato questa guida.