Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
-
Inserisci uno strumento di apertura nella giunzione tra la plastica bianca e la parte metallica dell’iPod. È comodo tenere l'iPod in alto e in basso come mostrato e spremere per aiutare a far uscire il bordo. Una volta inserito lo strumento di apertura, fallo scorrere lungo la giuntura per liberare le cinque alette che tengono insieme l'iPod.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the battery up from the adhesive holding it to the iPod.
-
Lay the battery next to the iPod (it is still connected to the logic board).
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully disconnect the orange ribbon cable from the hard drive.
-
If the cable doesn't come free easily, it may be helpful to gently wiggle the cable from side to side.
-
Lift the hard drive out of the iPod.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully disconnect the white battery connector from the logic board. Be sure to pull only on the connector itself and not on the cables.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Peel up the gray rubber bumper near the hard drive ribbon to reveal the T6 Torx screw beneath.
-
Remove the newly revealed T6 Torx screw.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the remaining 3 T6 Torx screws from the logic board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slide the logic board away from the port end of the casing and lift it out of the iPod.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a spudger to carefully disconnect the orange hard drive cable from beneath the scroll wheel.
-
Annulla: non ho completato questa guida.
Altre 4 persone hanno completato questa guida.