Salta al contenuto principale

Introduzione

Prerequisite-only guide for detaching the display assembly from the iPhone 8 Plus.

  1. Use the tip of a spudger or a fingernail to disconnect the large lower display connector by prying it straight up from its socket. To re-attach press connectors like this one, press down on one side until it clicks into place, then repeat on the other side. Do not press down on the middle. If the connector is even slightly misaligned, the connector can bend, causing permanent damage.
    • Use the tip of a spudger or a fingernail to disconnect the large lower display connector by prying it straight up from its socket.

    • To re-attach press connectors like this one, press down on one side until it clicks into place, then repeat on the other side. Do not press down on the middle. If the connector is even slightly misaligned, the connector can bend, causing permanent damage.

  2. Disconnect the second lower display cable connector, directly behind the one you disconnected in the previous step. Disconnect the second lower display cable connector, directly behind the one you disconnected in the previous step.
    • Disconnect the second lower display cable connector, directly behind the one you disconnected in the previous step.

  3. Remove the two tri-point Y000 screws securing the bracket over the front panel sensor assembly connector: One 1.0 mm screw
    • Remove the two tri-point Y000 screws securing the bracket over the front panel sensor assembly connector:

    • One 1.0 mm screw

    • One 1.2 mm screw

  4. Remove the bracket covering the front panel sensor assembly connector.
    • Remove the bracket covering the front panel sensor assembly connector.

  5. Use the tip of a spudger or a fingernail to disconnect the front panel sensor assembly connector from its socket. Use the tip of a spudger or a fingernail to disconnect the front panel sensor assembly connector from its socket.
    • Use the tip of a spudger or a fingernail to disconnect the front panel sensor assembly connector from its socket.

  6. Remove the display assembly.
Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 5 persone hanno completato questa guida.

Jeff Suovanen

Membro da: 06/08/2013

362.259 Reputazione

258 Guide realizzate

Team

iFixit Membro di iFixit

Community

141 Membri

17.045 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 18

Ultimi 30 Giorni: 69

Tutti i Tempi: 3,118