Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the screw that holds this bracket in and put it in a safe place.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use an automotive pick tool to lift the bracket up on the side of where the speaker lies. Slight upward pressure, do not force or pry.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Do the same with the other side and on the bottom of the bracket. This is held in with tension on fingers that clip into the screen midframe.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Once the bracket is loose, you can pull it up carefully maneuvering it up and around the LCD and digitizer connectors.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Peel the old ribbon from the bracket, note the orientation.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Peel off the adhesive backing protectors from the new ribbon, and line up the holes in the ribbon with the ones on the bracket as so.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a small screwdriver's shaft to conform the new ribbon to the bracket's contour. Light pressure is only needed.
-
At the top of the ribbon, note that there are two small holes. Align them with the two holes in the metal piece for a perfect fit.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the digitizer and LCD connectors and snap in the bracket/ribbon combo to finish it off.
-
Annulla: non ho completato questa guida.
Altre 60 persone hanno completato questa guida.
8 Commenti
Thanks for this. I ruined the proximity sensor cable when I was repairing another part on my wife's phone (!)
Your guide helped me get her phone back in perfect working order.
Thanks!
My pleasure!
I used this guide to replace my speaker + proximity cable since I damaged the cable when I replaced the iPhone battery. Worked like a charm and all is good again, thanks for this guide it helped me out big time!
No problem, thanks for the comment!
I did not have a automotive pick, but I found that a straight pin from a sewing kit made it pretty easy to pop this module off.