Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Introduzione

prereq to disconnect the digitizer

Parti

Nessuna parte specificata.

  1. Use the flat end of a spudger to lift the digitizer cable connector straight up off of its socket. Use the flat end of a spudger to lift the digitizer cable connector straight up off of its socket.
    • Use the flat end of a spudger to lift the digitizer cable connector straight up off of its socket.

  2. Slide the spudger under the battery side of the digitizer board to begin separating it from the rear case. Lift the digitizer board up to free the last of the adhesive. Lift the digitizer board up to free the last of the adhesive.
    • Slide the spudger under the battery side of the digitizer board to begin separating it from the rear case.

    • Lift the digitizer board up to free the last of the adhesive.

  3. Lift and remove the front panel from the iPad.
    • Lift and remove the front panel from the iPad.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Sam Goldheart

Membro da: 18/10/2012

422.984 Reputazione

547 Guide realizzate

Team

iFixit Membro di iFixit

Community

129 Membri

12.955 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 30