Aggiusta la tua roba Comunità Store

iPad 6 Wi-Fi Front Panel Assembly Replacement

Solo Prerequisita
Questa guida è destinata a essere usata solo come prerequisito per altre guide. Da sola è incompleta.

Introduzione

This is a prerequisite only guide for the front panel replacement.

Cosa ti serve

  1. iPad 6 Wi-Fi Front Panel Assembly Replacement, Front Panel Assembly: passo 1, immagine 1 di 2 iPad 6 Wi-Fi Front Panel Assembly Replacement, Front Panel Assembly: passo 1, immagine 2 di 2

    • Remove any tape covering the home button ribbon cable connector.

    Traduci

  2. iPad 6 Wi-Fi Front Panel Assembly Replacement: passo 2, immagine 1 di 3 iPad 6 Wi-Fi Front Panel Assembly Replacement: passo 2, immagine 2 di 3 iPad 6 Wi-Fi Front Panel Assembly Replacement: passo 2, immagine 3 di 3

    • Use the flat end of a spudger to flip the tab on the home button ribbon cable ZIF connector upward.

    • Carefully pull the home button ribbon cable straight out of the ZIF connector.

    Traduci

  4. iPad 6 Wi-Fi Front Panel Assembly Replacement: passo 3, immagine 1 di 3 iPad 6 Wi-Fi Front Panel Assembly Replacement: passo 3, immagine 2 di 3 iPad 6 Wi-Fi Front Panel Assembly Replacement: passo 3, immagine 3 di 3

    • Use a the flat end of a spudger or a fingernail to carefully pop the two digitizer cable connectors straight up from their sockets.

    • To avoid damaging your iPad, pry only on the connectors themselves, not on the socket on the logic board.

    Traduci

  5. iPad 6 Wi-Fi Front Panel Assembly Replacement: passo 4, immagine 1 di 2 iPad 6 Wi-Fi Front Panel Assembly Replacement: passo 4, immagine 2 di 2

    • Carefully peel the home button ribbon cable up off of the adhesive holding it to the rear case.

    Traduci

  6. iPad 6 Wi-Fi Front Panel Assembly Replacement: passo 5, immagine 1 di 2 iPad 6 Wi-Fi Front Panel Assembly Replacement: passo 5, immagine 2 di 2
    Attrezzo utilizzato in questo passaggio:
    Polyimide Tape
    $9.99
    Compra

    • Remove the front panel assembly.

    • If you experience "ghost" or "phantom" touch input issues with your new display, this can be resolved by adding a layer of very thin insulating tape, such as Kapton (polyimide) tape, to the highlighted areas on the back of the panel. iFixit panels come with the proper insulation, and should not require the addition of any tape.

    • Without the proper insulation, these areas of the digitizer can ground out against other components, causing touch input malfunction.

    • The insulation is not visible to the naked eye, and is different from the foam dust barrier strips found on many iPads.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Autore

con 1 altro collaboratore

Sam Goldheart

Membro da: 10/18/12

465.608 Reputazione

538 Guide realizzate

Distintivi: 48

+45 altri distintivi

Team

iFixit Membro di iFixit

Staff

135 Membri

16.731 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 132