Aggiusta la tua roba Comunità Store

iPad 4 Wi-Fi Power & Volume Button Assembly Replacement

Solo Prerequisita
Questa guida è destinata a essere usata solo come prerequisito per altre guide. Da sola è incompleta.

Introduzione

Internal Prereq.

Cosa ti serve

  1. iPad 4 Wi-Fi Power & Volume Button Assembly Replacement, Power & Volume Button Assembly: passo 1, immagine 1 di 1

    • Remove the following screws securing the power & volume button cable to the aluminum frame:

    • Two 5.5 mm Phillips #0

    • One 2.6 mm Phillips #0

    • Two 2.6 mm Phillips #0

    • The two screws located on top are angled into the aluminum frame. Be sure to always hold the screwdriver in line with the screw.

    Traduci

  2. iPad 4 Wi-Fi Power & Volume Button Assembly Replacement: passo 2, immagine 1 di 1

    • Remove the piece of plastic covering the volume buttons.

    Traduci

  3. iPad 4 Wi-Fi Power & Volume Button Assembly Replacement: passo 3, immagine 1 di 1

    • Remove the single 2.6 mm Phillips #00 screw holding the volume button frame to the aluminum frame.

    • This screw is angled into the aluminum frame. Be sure to always hold the screwdriver in line with the screw.

    Traduci

  5. iPad 4 Wi-Fi Power & Volume Button Assembly Replacement: passo 4, immagine 1 di 1

    • Wedge the edge of a plastic opening tool underneath the sleep/wake sensor, being careful to not damage the fragile cable.

    • Move the plastic opening tool around the sensor, releasing the adhesive.

    Traduci

  6. iPad 4 Wi-Fi Power & Volume Button Assembly Replacement: passo 5, immagine 1 di 2 iPad 4 Wi-Fi Power & Volume Button Assembly Replacement: passo 5, immagine 2 di 2

    • Slide the tip of a spudger underneath the power & volume cables, releasing the adhesive.

    Traduci

  7. iPad 4 Wi-Fi Power & Volume Button Assembly Replacement: passo 6, immagine 1 di 3 iPad 4 Wi-Fi Power & Volume Button Assembly Replacement: passo 6, immagine 2 di 3 iPad 4 Wi-Fi Power & Volume Button Assembly Replacement: passo 6, immagine 3 di 3

    • Using the tip of the spudger rather that the wide edge, release the adhesive underneath the volume button branch of the ribbon cable.

    • Continue sliding the tip of the spudger toward the top of the iPad, releasing the adhesive.

    • With the tip of the spudger still underneath the ribbon cable, gently lift the power button out of its socket in the aluminum frame.

    Traduci

  8. iPad 4 Wi-Fi Power & Volume Button Assembly Replacement: passo 7, immagine 1 di 1

    • Lift and remove the power & volume button cable out of the iPad.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 38