Aggiusta la tua roba Comunità Store

iPad 4 CDMA Home Button Control Board Replacement

Solo Prerequisita
Questa guida è destinata a essere usata solo come prerequisito per altre guide. Da sola è incompleta.

Introduzione

Prereq only for adhesive strips.

Cosa ti serve

  1. iPad 4 CDMA Home Button Control Board Replacement, Home Button Control Board: passo 1, immagine 1 di 1

    • Remove the two 2.1 mm Phillips #00 Phillips screws securing the home button control board to the home button mounting bracket.

    Traduci

  2. iPad 4 CDMA Home Button Control Board Replacement: passo 2, immagine 1 di 2 iPad 4 CDMA Home Button Control Board Replacement: passo 2, immagine 2 di 2

    • Wedge the flat edge of a plastic opening tool in between the right end of the home button control board and the home button mounting bracket.

    • Depress the plastic opening tool downwards to pry the adhesive securing the home button control board from the home button mounting bracket.

    • Repeat the procedure to release the adhesive underneath the left end of the home button control board.

    Traduci

  4. iPad 4 CDMA Home Button Control Board Replacement: passo 3, immagine 1 di 1

    • Lift and remove the home button control board up off the home button mounting bracket.

    Traduci

  5. iPad 4 CDMA Home Button Control Board Replacement: passo 4, immagine 1 di 2 iPad 4 CDMA Home Button Control Board Replacement: passo 4, immagine 2 di 2

    • Use the flat edge of a spudger to scrape the old adhesive off the bottom right corner of the front panel assembly.

    • If necessary, gently peel the old adhesive with a pair of tweezers.

    Traduci

  6. iPad 4 CDMA Home Button Control Board Replacement: passo 5, immagine 1 di 2 iPad 4 CDMA Home Button Control Board Replacement: passo 5, immagine 2 di 2

    • Gently place the home button control board on top of the home button mounting bracket.

    • Make sure the home button control board is lined up with the bottom of the home button mounting bracket.

    Traduci

  7. iPad 4 CDMA Home Button Control Board Replacement: passo 6, immagine 1 di 1

    • Insert the two 2.1 mm Phillips #00 Phillips screws back into the home button control board to secure it against the home button mounting bracket.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 137