Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
If your display glass is cracked, keep further breakage contained and prevent bodily harm during your repair by taping the glass.
-
Lay overlapping strips of clear packing tape over the iPad's display until the whole face is covered.
-
Do your best to follow the rest of the guide as described. However, once the glass is broken, it will likely continue to crack as you work, and you may need to use a metal prying tool to scoop the glass out.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert a metal spudger between the right edge of the display assembly and the rear panel assembly.
-
Rotate the spudger away from you to release the tabs along the top edge of the display.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert a second metal spudger between the top edge of the display assembly and the rear panel assembly to keep the tabs from snapping back into place.
-
Pry the display assembly away from the rear panel.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Continue prying the display assembly away from the rear panel along the bottom and left edges of the iPad.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the display assembly away from the rear panel assembly by its bottom edge.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the flat end of a spudger to pry the antenna connector closest to the bottom of the iPad up off its socket on the communications board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
In the following steps, you will disconnect the three cables attaching the display assembly to the logic board. The cables are for the following components:
-
Digitizer
-
Ambient Light Sensor
-
Display Data Cable
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the edge of an iPod opening tool to flip up the retaining flaps holding the digitizer ribbon cables in their sockets on the logic board.
-
Pull the digitizer ribbon cables straight out of their sockets.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use an iPod opening tool to remove the ambient light sensor connector from its socket by gently prying upward.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disconnect the display data cable from the main board by flipping up the metal retainer by its black plastic pull tab.
-
Pull the cable connector away from its socket.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the display assembly from the rear panel assembly.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the edge of an iPod opening tool to carefully pry the remaining antenna connector up off the communications board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
De-route the control button cable along the top edge of the communications board.
-
Pull the communications cable upward to lift its connector up and out of the socket on the logic board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the single T5 Torx screw securing the communications board to the rear case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull the communications board away from its socket on the logic board.
-
Annulla: non ho completato questa guida.
Altre 11 persone hanno completato questa guida.