Aggiusta la tua roba Comunità Store

iPad 2 CDMA Headphone Jack Assembly Replacement

Solo Prerequisita
Questa guida è destinata a essere usata solo come prerequisito per altre guide. Da sola è incompleta.

Introduzione

Prereq only.

Cosa ti serve

  1. iPad 2 CDMA Headphone Jack Assembly Replacement, Headphone Jack Assembly: passo 1, immagine 1 di 3 iPad 2 CDMA Headphone Jack Assembly Replacement, Headphone Jack Assembly: passo 1, immagine 2 di 3 iPad 2 CDMA Headphone Jack Assembly Replacement, Headphone Jack Assembly: passo 1, immagine 3 di 3

    • Use the flat end of a plastic opening tool to flip up the retaining flap on the headphone jack and front-facing camera ribbon cable ZIF socket.

    • Be sure you are prying up on the hinged retaining flap, not the socket itself.

    • Run a plastic opening tool underneath the headphone jack and front-facing camera cable to free it from the adhesive attaching the cable to the rear panel.

    • Pull the headphone jack and front-facing camera ribbon cable straight out of its socket on the logic board.

    Traduci

  2. iPad 2 CDMA Headphone Jack Assembly Replacement: passo 2, immagine 1 di 1

    • Remove the two 2.9 mm Phillips screws securing the headphone jack to the rear panel.

    Traduci

  4. iPad 2 CDMA Headphone Jack Assembly Replacement: passo 3, immagine 1 di 1

    • Use a plastic opening tool to help pull the headphone jack away from its recess in the top edge of the iPad.

    • Don't try to remove the assembly just yet.

    Traduci

  5. iPad 2 CDMA Headphone Jack Assembly Replacement: passo 4, immagine 1 di 1

    • Carefully peel the front camera and microphone cables off the rear panel.

    Traduci

  6. iPad 2 CDMA Headphone Jack Assembly Replacement: passo 5, immagine 1 di 2 iPad 2 CDMA Headphone Jack Assembly Replacement: passo 5, immagine 2 di 2

    • Carefully remove the strip of tape covering the front camera cable connector.

    • Use the edge of a plastic opening tool to disconnect the front camera cable from the headphone jack cable.

    Traduci

  7. iPad 2 CDMA Headphone Jack Assembly Replacement: passo 6, immagine 1 di 1

    • Carefully peel the front camera cable off the bottom ribbon cable attached to the headphone jack.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

con 3 altri collaboratori

Phillip Takahashi

Membro da: 08/22/11

86.704 Reputazione

87 Guide realizzate

Distintivi: 43

+40 altri distintivi

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 421