Introduzione

The ins and outs of replacing your microphone.

Before you work on the computer, unplug the computer and press the power button for 20-30 seconds to drain the stored energy in the power supply.
  • Before you work on the computer, unplug the computer and press the power button for 20-30 seconds to drain the stored energy in the power supply.

  • Loosen the two Phillips screws securing the access door to your iMac.

  • These screws are captive in the access door.

Aggiungi Commento

Remove the access door from your iMac.
  • Remove the access door from your iMac.

Aggiungi Commento

  • Remove the three T8 Torx screws securing the front bezel to the rear panel.

Aggiungi Commento

  • Orient the iMac face-up, on its backside.

  • Use your thumbs to press both RAM arms in past the front bezel for enough clearance to lift it off the rear case.

Aggiungi Commento

  • While holding the RAM arms in with your thumbs, lift the lower edge of the front bezel enough to clear the rear case.

Aggiungi Commento

  • Re-orient your iMac so it sits upright on the stand.

  • Insert a plastic card up into the corner of the air vent slot at the top of the rear case.

  • Push the card toward the top of the iMac to release the front bezel latch.

  • Pull the front bezel away from the rear case.

  • Repeat this process for the other side of the front bezel.

  • It may be necessary to apply several layers of duct tape to the top of the access card to aid in releasing the latches.

  • If the bezel refuses to release, try pressing the lower edge back onto the rear case and repeat this opening process.

Using a strongish magnet will grab and release the latches.

darkstar448 - Replica

Citazione da darkstar448:

Using a strongish magnet will grab and release the latches.

Are you sure it's safe to do this? How close is the hard drive, won't magnets interfere with it?

Sarah - Replica

It's almost certainly fine. Modern hard drives are very resistant to magnetic fields.

zschroeder6212 -

  • Lay your iMac stand-side down on a table.

  • Lift the front bezel from its lower edge and rotate it away from the rest of your iMac, minding the RAM arms that may get caught.

  • Lay the front bezel above the rest of the iMac.

Aggiungi Commento

  • If necessary, remove the piece of kapton tape wrapped around the microphone and camera cables.

Aggiungi Commento

  • Disconnect both the camera and microphone cables.

Aggiungi Commento

  • Lay the bezel front side down on a table.

  • If necessary, peel back the tape covering the camera board.

Aggiungi Commento

  • Remove the two T6 Torx screws securing the camera board to the front bezel.

Aggiungi Commento

  • Lift the camera board out from the front bezel.

Aggiungi Commento

  • Use a spudger to pry the microphone off the adhesive holding it to the front bezel.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 2,994