Salta al contenuto principale

Introduzione

This is a cleaning and replacement guide for the iHome iH5.

  1. Remove the eight screws from the bottom side of the iHome.
    • Remove the eight screws from the bottom side of the iHome.

  2. Remove the cover to expose the inside.
    • Remove the cover to expose the inside.

    • With pliers, or tweezers,if needed, remove the three wire harnesses by gently pulling straight up on them.

  3. Remove the 5 screws with a #2 Phillips screwdriver.
    • Remove the 5 screws with a #2 Phillips screwdriver.

  4. Kit di riparazione per Android

    A new screen or battery is one kit away.

    Acquista ora

    Kit di riparazione per Android

    A new screen or battery is one kit away.

    Acquista ora
  5. Remove all wire harnesses from the bottom of the board. There eight wire harnesses.
    • Remove all wire harnesses from the bottom of the board. There eight wire harnesses.

    • There are capacitors all over the back side of the board. Be careful not to touch these capacitors (blue cylinders) as they can discharge—giving you a shock.

  6. Remove the two screws from the speakers with a #2 Phillips screwdriver. Turn the device on its front side and remove the two screws with a #2 Phillips screwdriver. Pull the speaker up from the back as shown with the speaker on the right. Then pull the speaker straight back as shown with the speaker on the left.
    • Remove the two screws from the speakers with a #2 Phillips screwdriver.

    • Turn the device on its front side and remove the two screws with a #2 Phillips screwdriver.

    • Pull the speaker up from the back as shown with the speaker on the right. Then pull the speaker straight back as shown with the speaker on the left.

  7. Remove the front piece by pulling up until it hits the plastic pieces sticking out from the display screen. Then pull it out horizontally from the device.
    • Remove the front piece by pulling up until it hits the plastic pieces sticking out from the display screen. Then pull it out horizontally from the device.

  8. Remove the three screw from the dial with a #2 Phillips screwdriver.
    • Remove the three screw from the dial with a #2 Phillips screwdriver.

  9. Pull back the circuit board to access the plastic piece.
    • Pull back the circuit board to access the plastic piece.

    • Lift to separate the plastic piece from the dial.

    • Replace the broken piece.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 3 persone hanno completato questa guida.

Maggie Hill

Membro da: 20/03/2014

379 Reputazione

3 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 7

Tutti i Tempi: 720