Introduzione

This is a replacement guide for the charging dock on the iHome iH5.

Parti

Nessuna parte richiesta.

Remove the eight 5/16 inch screws with a #2 Phillips screwdriver.
  • Remove the eight 5/16 inch screws with a #2 Phillips screwdriver.

Aggiungi Commento

Use tweezers to unplug the three wires connected to the circuit board. If the wires are tight pliers might work better.
  • Use tweezers to unplug the three wires connected to the circuit board. If the wires are tight pliers might work better.

Aggiungi Commento

  • Remove the five 5/16 inch screws from the circuit board.

Aggiungi Commento

  • Flip the circuit board over.

  • There are capacitors all over the back side of the board. Be careful not to touch these capacitors (blue cylinders) as they can discharge—giving you a shock.

  • Unplug the eight wires attached to the circuit board with tweezers. If the wires are tight pliers might work better.

    • There is on wire in the orange box.

    • There are two wires in the yellow box.

    • There are five wires in the green box.

Aggiungi Commento

  • Remove the following four screws securing the iHome iH5 charging dock.

    • Use a #2 Phillips screwdriver to remove the four screws.

Aggiungi Commento

  • Gently remove the charging dock from the iHome iH5 by pulling it up.

Aggiungi Commento

  • Remove the final screws connecting the iH5 charging dock to the plastic holding platform

    • Use a #2 Phillips screwdriver to remove the 3/8 inch screws.

Aggiungi Commento

  • Replace the old iH5 charging dock with new iH5 charging dock.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Dustin Lamb

Membro da: 13/03/2014

103 Reputazione

1 Guida realizzata

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 16

Tutti i Tempi: 605