Introduzione

Replacing this keyboard is easy and takes only a few minutes.

Use a coin to rotate the battery locking screw 90 degrees clockwise.
  • Use a coin to rotate the battery locking screw 90 degrees clockwise.

Aggiungi Commento

Lift the battery out of the computer.
  • Lift the battery out of the computer.

Aggiungi Commento

  • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

  • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again.

  • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

Aggiungi Commento

  • If the computer has an AirPort card installed, follow the next three steps to remove it.

  • Push the wire clasp away from the AirPort card and toward the display, then rotate up to free it from the RAM shield.

Aggiungi Commento

  • Grasp the clear plastic tab on the AirPort card and pull toward the display.

Aggiungi Commento

  • Hold the AirPort card in one hand and use your other hand to remove the antenna cable.

Aggiungi Commento

  • Remove the four silver Phillips screws that secure the RAM shield.

Aggiungi Commento

  • Grasp the metal bracket on top of the RAM shield and pull upward to remove the shield.

Aggiungi Commento

  • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

  • Make sure that you reconnect the keyboard cable before replacing the RAM shield.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 4 persone hanno completato questa guida.

Documenti Allegati

iRobot

Membro da: 24/09/2009

1 Reputazione

774 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 9

Tutti i Tempi: 11,680