Introduzione

Remove your rear display bezel to access your display's internals.

Lay your iBook upside down on a flat surface.
  • Lay your iBook upside down on a flat surface.

  • Use a coin to rotate the battery locking screw 90 degrees clockwise.

  • Lift the battery out of the computer.

Aggiungi Commento

Use a 1.5mm hex screwdriver to remove the two hex screws on either side of the display (four screws total).
  • Use a 1.5mm hex screwdriver to remove the two hex screws on either side of the display (four screws total).

  • If you don't have a 1.5mm hex driver, you can probably get these screws out with a T6 Torx screwdriver. However, if you use a T6 Torx driver you'll be more likely to strip the screws.

Aggiungi Commento

  • Insert the flat end of a spudger perpendicular to the face of the display into the gap between the front and rear bezels near the upper left corner of the display.

  • Rotate the spudger away from the display to pry the rear bezel off the front bezel.

Aggiungi Commento

  • Run your spudger along the top edge of the front display bezel to evenly separate the two bezels.

Aggiungi Commento

  • Working down from the upper left corner, use the flat end of a spudger to pry the rear bezel away from the left edge of the display.

Aggiungi Commento

  • Use the flat end of a spudger to pry the rear bezel away from the right edge of the display.

  • If necessary, pry along the bottom edge of the rear bezel to separate it from the display assembly.

Aggiungi Commento

  • Lift the rear bezel off the display assembly.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 3 persone hanno completato questa guida.

Documenti Allegati

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 3,191