Salta al contenuto principale

Modifiche al passo #1

Modifica in base a Sahil Sharma-

Modifica approvata da Sahil Sharma

Prima di
Dopo il

Righe Passo

[* red] Use a Phillips #1 screwdriver to loosen the four (4) large silver screws evenly in the order of the numbers engraved next to each screw.
[* orange] Use a Phillips # 0 to loosen the other four (4) 2mm screws evenly in the order engraved on the copper next to each screw.
[* black] Repeat the last two bullets until all the larger silver screws make a clicking sound and the 2mm screws are removed.
[* icon_note] The silver screws cannot be completely removed.
[* black] Peel away the black tape between the RAM shield and the heat sink.
[* icon_reminder] When reattaching the heat sink to the motherboard, make sure to tighten the screws a little bit at a time, in the same order as before, until they are all snug.