Salta al contenuto principale

Modifiche al passo #3

Modifica in base a ndsol-

Modifica approvata da ndsol

Prima di
Dopo il
Invariato

Righe Passo

[title] Install parts and fill with oil
-[* black] Open the new oil containers. Place a little oil on the rubber gasket of the new oil filter.
-[* black] Install the new filter only hand-tight. Then tighten it one-half turn further.
-[* black] Replace the oil drain plug. Tighten it to 29 ft-lb of torque using a torque wrench. (It is best to under-tighten the oil drain plug. If it is over-tightened you may crack the oil pan!)
+[* black] Place a little oil on the rubber gasket of the new oil filter. Then install the new filter only hand-tighten.
+[* black] Tighten the new oil filter one-half turn further than hand-tight, using an oil filter wrench.
+[* black] The oil drain plug has a crush washer that needs to be replaced. Then put the plug back on and tighten it to 29 ft-lb of torque using a torque wrench. (It is best to under-tighten the oil drain plug. If it is over-tightened you may crack the oil pan!)
[* black] Pour 3 quarts (not all 4) into the oil tank.
[* black] Check for leaks.
-[* black] Remove the oil pan with the used oil. Clean up under the car.
+[* black] Remove the used oil in the drain pan under the car. Clean up under the car.
[* black] Lower your vehicle so it is resting on the ground and is level.
[* black] Use the dipstick to check the oil level. Add a little of the remaining oil, and check the dipstick again. Continue adding some oil until the dipstick shows the oil level is full.