Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Modifiche al passo #1

Modifica in base a Adam O'Camb-

Modifica approvata da Adam O'Camb

Prima di
Dopo il
Invariato

Righe Passo

[* black] Peel off the four black tamper-evident stickers covering the heat sink mounting screws.
[* red] Remove the four T9T10 screws that secure the heat sink from the backside of the logic board.
[* red] Remove the four T9T10 screws that secure the heat sink from the backside of the logic board.
[* icon_reminder] During reassembly, tighten these screws one full turn at a time, [https://d3nevzfk7ii3be.cloudfront.net/igi/Mkb4dN2AH1AGwe3F|alternating in a cross pattern|new_window=true]. This will gradually increase the clamping pressure evenly across the surface of the CPU. Continue gradually tightening the screws until they're snug and the entire spring plate [https://d3nevzfk7ii3be.cloudfront.net/igi/1NED52iMbNDN3NUF|lays flat|new_window=true] against the logic board.