Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Modifiche al passo #1

Modifica in base a Jeff Suovanen-

Modifica approvata da Jeff Suovanen

Prima di
Dopo il
Invariato

Righe Passo

[* black] Peel off the four black tamper-evident stickers covering the heat sink mounting screws.
[*
red] Remove the four T9 screws that secure the heat sink from the back-sidebackside of the logic board.
[* black] Lift

[* icon_reminder] During reassembly, tighten these screws one full turn at a time, [https://d3nevzfk7ii3be.cloudfront.net/igi/Mkb4dN2AH1AGwe3F|alternating in a cross pattern|new_window=true]. This will gradually increase
the heat sink retaining springclamping pressure evenly across the surface of the CPU. Continue gradually tightening the screws until they're snug and its bracket offthe entire spring plate [https://d3nevzfk7ii3be.cloudfront.net/igi/1NED52iMbNDN3NUF|lays flat|new_window=true] against the logic board.
[* black] Peel off the four black tamper-evident stickers covering the heat sink mounting screws.
[*
red] Remove the four T9 screws that secure the heat sink from the back-sidebackside of the logic board.
[* black] Lift

[* icon_reminder] During reassembly, tighten these screws one full turn at a time, [https://d3nevzfk7ii3be.cloudfront.net/igi/Mkb4dN2AH1AGwe3F|alternating in a cross pattern|new_window=true]. This will gradually increase
the heat sink retaining springclamping pressure evenly across the surface of the CPU. Continue gradually tightening the screws until they're snug and its bracket offthe entire spring plate [https://d3nevzfk7ii3be.cloudfront.net/igi/1NED52iMbNDN3NUF|lays flat|new_window=true] against the logic board.

Immagine 1

Vecchia Versione

Nuova Versione

Immagine 2

Vecchia Versione

Nuova Versione

Immagine 3

Eliminato