Aggiusta le tue cose Community Store

Modifiche al passo #2

Modifica di Adam O'Camb —

Modifica approvata da Adam O'Camb

Prima di
Dopo il
Invariato

Righe Passo

-[* black] In the following steps you will be cutting through the adhesive around the edge of the rear glass panel.
-[* black] Areas of interest are as follows.
- [* red] Areas of adhesive (in addition to the adhesive on the edge of the rear case).
+[* black] In the following steps you will be cutting through the adhesive on the rear glass panel.
+[* black] Take note of the following areas:
+ [* red] In addition to cutting around the edge, there is extra adhesive here that should be cut.
[* orange] Avoid sticking the spudger blade in too far here, to avoid damaging the rear button ribbon cable and chip.